Tianjin Jiangjin Pipeline Dredging Co., Ltd.

Floor heating cleaning can be done before, during or after heating. Cleaning before heating can remove all biological slime and impurities in the pipes, thereby ensuring the normal use of the floor heating pipes during heating and achieving the best indoor temperature. When cleaning under heating, you can intuitively feel the changes in temperature rise. Cleaning after heating is the most important, because the water quality during the heating period is poor. In order to prevent users from stealing water, some heating companies will add dyes and other substances into the heating water. Such substances will cause the water quality to decrease and promote the deposition of impurities. At this time, if the above substances are not completely removed, a large number of bacteria will breed and cause serious harm to the user's health. Therefore, regular cleaning and maintenance of the water floor heating system is very important. Personally, I feel that summer is the best time to clean floor heating. If there is no heating in summer, and the floor heating pipes are not used for a long time, the water inside will produce corrosive products at high temperatures, which will have a certain corrosive effect on the pipes. Cleaning the floor heating pipes is equivalent to cleaning the pipes. Inject new water from the new one, and it can also flush out the dirt inside. There are currently three methods of geothermal cleaning: First, chemical cleaning: Chemical cleaning should be said to have a very good cleaning effect, but it is rarely used because it easily causes corrosion and aging effects on geothermal pipes and system components, as well as pollution caused by emissions.
The second is projectile cleaning: For projectile cleaning, remove the geothermal tube from the water distributor, place the cleaning bomb in the pneumatic gun or the geothermal tube, then stick the pneumatic gun on the geothermal tube, and use compressed air to Inject the cleaning projectile into the geothermal tube and come out from the other end of the tube to achieve the purpose of cleaning. A good cleaning effect can restore the tube to its original color. The disadvantage is that the tube removal efficiency is relatively low, and it is easy to jam when the geothermal tube has joints and bends.
The third is pulse cleaning: the medium of pulse cleaning is gas and water. The purpose of cleaning is achieved by the pulse wave and vibration wave mixed with gas and water to impact and vibrate the inner wall of the geothermal tube. The main equipment is the pulse generator and accessories. Connect to the plug of the water distributor and clean them one by one without removing the pipe. The cleaning effect is relatively good. It can clean out more than % of the dirt and deposits in the tube and quickly remove it from the tube. After cleaning, the color of the tube can be significantly lighter. Simple operation, safe and environmentally friendly. It is currently the mainstream method of geothermal cleaning.