(>Cleaning geothermal pipes 1. The necessity of cleaning floor heating (geothermal) pipes. Floor heating (geothermal) pipes have accumulated water for many years. There are microorganisms in the water. Under certain conditions, a large amount of biological slime will be produced to cover the inner wall of the geothermal pipes. , the temperature change of geothermal heat is caused by the biological slime covering the inner wall of the pipe wall. At the same time, a large number of bacteria survive, which also causes harm to human health. 2. Floor heating (geothermal) pipe cleaning cycle New floor heating (geothermal) ) If the service life exceeds two heating periods, regular maintenance and upkeep are required. Thereafter, the geothermal pipes will be cleaned once every heating period, because biological slime, impurities, and bacteria will be produced after use. In order to ensure that the geothermal pipes are in good condition. The heat dissipation function and the cleaning of the inner wall extend the service life of the geothermal pipe, so regular maintenance and upkeep of the geothermal pipeline system is inevitable. 3. The harm caused by uncleaned floor heating (floor heating) pipes, the indoor temperature of the user's home is now significantly higher than before The indoor temperature has decreased: This is because a large amount of biological slime is produced on the inner wall of the geothermal pipe. According to relevant statistics, during the heating process, every time scale is added to the inner wall of the geothermal pipe, the ambient temperature will drop by ℃. This not only affects the Normal temperature, but also causes a waste of energy and increases the economic cost of heating. The internal diameter of the floor heating pipe is small. If it is not cleaned for a long time, there will be more and more biological slime, impurities, and scale in the circulating water, and the water flow of the geothermal pipe will obviously feel This year is smaller than previous years: It is possible that there is too much biological slime in the geothermal pipes, which has caused partial blockage of the geothermal pipes. Continued use will cause blockage in the pipes. This can only be solved by destroying the ground and dismantling or replacing the geothermal pipe system. , causing you serious property losses and life inconvenience. 4. Introduction to floor heating (geothermal) With the widespread application of floor radiant heating in new projects and civil buildings, floor radiant heating has been regarded as the preferred heating method. The use of floor radiant heating The main forms are low-temperature hot water floor radiant heating and heating cable floor radiant heating. In our country, buildings above use low-temperature hot water floor radiant heating. Most of them use R and pipes as geothermal pipes laid in the cement mortar layer under the floor. With the development of floor heating With the increase in users, many doubts and difficult-to-solve problems have also arisen. Whether the system design is reasonable, the laying position of the floor heating pipes, the size of the water pipe gaps, the thickness of the pipe diameter, etc. will all affect the later heating. Even if there is no problem with the design and paving , but if the design drawings are not fully followed during the construction process, it will also cause lack of heat. At the same time, because the water in the floor heating system contains a large amount of minerals, calcium and magnesium ions, due to changes in the supply and return water temperature, calcium and magnesium ion scale will be produced and adhere to the pipes. Pipe scale is formed on the inner wall of the road. This causes the water flow to weaken and the heat transfer effect to decrease, causing the room temperature to drop and affecting the normal quality of life. In addition, the water in the floor heating system contains a large number of microorganisms and will produce a large amount of biological slime under suitable conditions. Covering the inside of the pipe wall, causing the pipe to turn green or black. If it is not effectively cleaned for a long time, the geothermal heating system will malfunction, causing the embolism in the pipe to become unusable. It may even cause damage to the ground and dismantle or replace the geothermal pipe system. , causing property losses and inconvenience to floor heating users. 5. The cleaning and descaling method of Beijing Huachen Tengda floor heating (floor heating) uses air pressure pulse physical cleaning method and chemical cleaning agent cleaning and descaling method. The cleaning time is short, the cleaning effect is good, and the cleaning cost is low. , Floor heating (geothermal) pipeline physical cleaning method, high-pressure pulse cleaning, adopts a fully automatic intelligent pulse geothermal cleaning machine, using the principle of controllable air pressure pulse, the gas and water mixed medium uses strong pressure to generate high-pressure water jets to impact the pipeline at extremely high speed, and the gas and water The principle of cavitation and water hammer phenomenon generated during the pulse process
Tianjin Port Professional Pulse High Pressure Cleaning Floor Heating